GRAUPNER/SJ GmbH D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors.
3/2013
-
6
-
Glue the shaped upper nose panel (15) in place. Sand the front face of the fuselage
flat before gluing the noseblock (16) in place. Glue the flanged nut (17) to the tail-
plane support (18) and glue it to the fuselage as shown.
Assemble the fin and rudder from parts (19) to (21) using cyano. Refer to section D-D
on plan sheet 1; do not use activator spray for these joints. Sand the fin to the profile
shown in section D-D, and check that the rudder deflects freely to both sides. Trial-fit
the fin assembly in the slot in the fuselage. Check from the nose of the fuselage that
the fin is exactly vertical, then glue it in place permanently.
