GRASS VALLEY JUPITER -, Инструкция по установке и эксплуатации

Страница: 212 / 310

212 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 5 — The Configurator Application
AccuSwitch Software Configuration
Each system must be configured to recognize the other systems. The fol-
lowing instructions assume you are familiar with standard Jupiter config-
uration rules.
The following tables will need to be modified:
• Network Description tables
• Switcher Description tables
• CP Level Set tables
• MPK Devices tables
• Switcher Input Tables − both servers
• CP Input Sets − both servers
• Switcher Output Tables − both servers
• CP Output Sets − both servers
Detailed instruction for modifying these tables is provided in the sections
below.
Network Description Tables
The following examples correspond to the two systems that are shown in
Figure 155 on page 210 .
The Network Description table for System 1 (which is shown in the top half
of
Figure 155 ) is shown in Figure 156 . The Network Description table for
System 2 (which is shown in the bottom half of Figure 155 on page 210 ) is
shown in Figure 157 on page 213 .
Note Connection to the Internet through a firewall is not supported.
Network Description table on System 1’s Server
Figure 156. Example of the Network Description Table on the System 1 Server
27512_Network Description table_System
004053011C21
Redundant
2
Network Description
Board Name
SYS1 AS
Address
3
SYS2 ES 192.168.254.10
1
Type
Address