GRASS VALLEY JUPITER -, Инструкция по установке и эксплуатации

Страница: 170 / 310

170 JUPITER CM-4400 Control Module Installation and Operating Manual
Section 5 — The Configurator Application
Note Output passwords are not honored by automation protocol handling.
In most cases, you will want to modify the set that is currently active; if so,
you may want to copy the active set and select the copy for editing. For
more information, please see
Copying a Configuration Set for Editing on
page 130 .
On the top of the Jupiter Configurator window on the title bar, you will see
the name of the Configuration set. Check to see whether the configuration
set that you want to change is selected.
Follow these steps to set the password level for Switcher outputs:
1. Select the Switcher Output option from the Jupiter menu (Jupiter>
Switcher Output). The Switcher Output table will then open
(
Figure 120 ).
In this example, the password level column is blank, meaning that all
outputs have a password level of zero. Therefore all passwords pres-
ently assigned will allow changing the signal being sent to any output.
2. Click on the password field that you want to change.
3.
Enter the preferred password level for this output. Entering a level of
“50” would mean that only passwords having levels of 50 or more
could be used to enable selection of an input for this output.
4. Save the changes by selecting Save from the File menu (File > Save).
5.
Click the
OK
button to save the table.