GRASS VALLEY GV MATRIX, Руководство пользователя

Страница: 26 / 115

10
Getting Started
Setting the GV Matrix’s IP Address
See Setting the GV Matrix’s IP Address , on page 10 for instructions on replacing these with
settings that apply to your local network, so that the GV Matrix can be located by control
applications such as Grass Valley’s iControl.
Note:
The GV Matrix should be located in the same subnet as the
iControl Application Server that will control it.
Once the ETH1 port settings have been configured, you can connect your GV Matrix to the
network via the rear controller connection panel. See
Connecting the GV Matrix to your
Network , on page 12.
You must install and configure iControl or iControl Solo before you can configure your GV
Matrix.
Notes
• For detailed information about iControl , refer to the iControl User Guide,
available from the Documentation Library section of Grass Valley’s
website.
• For detailed information about iControl Solo, refer to the iControl Solo User
Guide, available from the the Documentation Library section of Grass
Valley’s website.
iControl Solo is available from the Downloads section of the Grass Valley
website.
• GV Matrix is compatible with iControl version 7.20 and later, and iControl
Solo version 7.20 build 52 and later.
Once the GV Matrix is connected to the network, you can use iControl or iControl Solo to
configure the GV Matrix. See
Registering your GV Matrix to iControl , on page 12, for
detailed instructions on setting up the connection between your GV Matrix and iControl.
Setting the GV Matrix’s IP Address
To set the GV Matrix’s IP Address
1 On the GV Matrix control panel, touch CTRL .
The GV Matrix controller menu appears on the display.