Enter “ <User ID Number>#”
*
To Change a User Code
Enter <old User Code> #
RED LED goes YELLOW
YELLOW LED goes
GREEN for 1/2 sec if OK or
beep beep beep if not OK
RED flashing LED goes green
for 1/2 sec. then RED no flash
Enter “<new User Code>#”
(4 digits)
Enter “<new User Code>#”
(4 digits) to confirm
press “ # ” then “ ” to exit
programming mode
*
Record Master Code Here:
Programming Instructions for MAW6 Digital Keypad
To Change the Master Code
Record User ID numbers and Codes Here:
Enter “ <Master Code># ”
Factory code “ 999-999 ”
*
RED flashing LED goes green
for 1/2 sec. then RED no flash
press “ 0 ”
RED LED goes YELLOW
YELLOW LED goes
GREEN for 1/2 sec if OK or
beep beep beep if not OK
Enter “<new Master Code>#”
(6 to 8 digits)
Enter “<new Master Code>#”
(6 to 8 digits) to confirm
press “ # ” then “ ” to exit
programming mode
*
User Name and/or Description
User ID Number
User Code
Restoring Factory Settings.
The factory settings can be recov-
ered it necessary without loosing
any user codes, tags or cards pro-
grammed in. To do this remove
power from the device, then after
15 seconds press and hold the “#’
key and restore power. When the
decive beeps left go of the “#” key
as the factory settings have been
restored.
www.grantsautomation.com.au - [email protected]
