Grant C1G, Руководство по эксплуатации

Страница: 5 / 12

2. Getting Started
2.1 Unpacking
Remove the packing materials carefully, and retain for future shipment or storage.
2.1.1 Cooler
C1G:
The pack should contain:
C1G Cooler
Mains cable
Cooling coil locator pack
These instructions.
C2G:
The pack should contain:
C2G Cooler
Mains cable
Cooling coil locator pack
These instructions
2.2 Installation
WARNING: The equipment must be earthed (grounded). It is protected by electrical fuses. We
strongly recommend that the power supply to any equipment for heating liquids should include a
residual-current circuit breaker (earth leakage trip).
Check that the voltage rating of the products, given on the serial plate at the power cable
entry, is correct for your supply.
Fit the mains cable into the IEC socket at the rear of the unit. The mains (power) switch is at the
rear of the unit.
Switch on at the rear. Always ensure that the bath is switched on to provide temperature control,
and to prevent the formation of ice
Do not switch on if :
-
the temperature of the liquid in the bath is above 100°C
-
the cooler has been tilted by more than 25° during the past six hours
- the interval since switching off the cooling system is less than 10 minutes
Condensed water vapour from the air will dilute water/glycol mixture and eventually ice will form on
the cooling coil. This should be removed and liquid replaced, otherwise cooling power will be
reduced.
2.2.1 C1G, C2G
The C1G and C2G are designed for use with the Grant Optima, Y and W Series baths. The C2G
is only suitable for fitting in the 26, 28 and 38 litre baths.
For fitting coiling coil in the Optima, Y and W series baths refer to instruction included with cooling
coil locator pack.
Ensure that the unit is located so that the ventilation grilles are not less than 100mm from any
obstruction.
The cooling coil may be immersed in liquids up to 100°C but the cooler should only be used to cool
down the liquid not to operate continuously above 40°C.
Immersed material: the cooling coil is nickel plated copper.