Grant Afinia GALU430 KIT Series, Руководство по установке

Страница: 8 / 16

table 3-2: Dimensions for figure 3-3
no. of
Sections
Dimensions
mm
a B C D
6 480 92 320 68
8 640 172 320 148
10 800 172 480 148
12 960 252 480 228
14 1120 252 640 228
Section 3: installation page 8
The bushes supplied in the installation pack (see Section 1.3)
must be fitted before mounting the radiator on the wall.
! CaUtiOn !
The 1” BSP connections on Grant Afinia radiators are left
hand threaded on the left-hand end of the radiator (viewed
from the front) and right hand threaded on the right-hand
end.
Fit the two 1”x½” bushes with the LEFT-HAND thread into the two
connections at the LEFT-HAND end of the radiator. Similarly, fit
the two 1”x½” bushes with the RIGHT-HAND thread into the two
connections at the RIGHT-HAND end of the radiator.
Take care to ensure that the correctly threaded bush is used as
the threads can be easily damaged and cause leaks if forced or
incorrectly fitted. The recommended tightening torque is 30-40Nm.
! CaUtiOn !
the four bushes, air vent and blanking plug are all supplied
with their own sealing rings fitted. NO sealant of any kind,
plumbers’ hemp or PTFE tape should be used when fitting
these items to the radiator.
Fit the radiator vent to one of the bushes at the top of the radiator
and the blanking plug to the remaining open bush after allowing
for the location of the radiator valves (not supplied).
TBOE BBOE TBSE
figure 3-2: pipe Connection Options
Fit the radiator valve tails to the radiator bushes using only PTFE
tape to seal. If any sealant is used great care must be taken to
ensure that it does NOT come into contact with the sealing rings
on the bushes as this may lead to water leaks.
When tightening the tails, firmly grip the bush with a good fitting
spanner or wrench to prevent it from turning. Recommended
tightening torque is 30-40Nm.
3.4 inStaLLatiOn pROCEDURE
Refer to Figures 3-3, 3-4, 3-5 or 3-6 and Tables 3-2, 3-3 or 3-4,
corresponding to the radiator being fitted, for the fixing hole
dimensions relative to the outer edges of the radiator.
Using a spirit level, mark the position of the fixing holes for the
radiator mounting brackets on the wall so the radiator, once fitted,
will be in the required position. Refer to Section 3.2 of these
Instructions for minimum distances from floor and overhanging
surfaces.
B C D
A
89
243
98
430
286
85
34
350
63
95
Grant Afinia Aluminium Radiator
430mm High
Front View (brackets obscured)
Side View
Fixing Holes
1" BSP
Female
Connections
Mounting
Brackets
Outline of
Radiator
figure 3-3: fixing hole positions for Horizontal 430mm high radiators