07
engine checked. It may be that the car battery is defective as well and refuses to accept the cur-
rent from the Jump Starter.
This Start Booster can also be used as a source of power. For example, you can use a 12V OBD
Memory Saver cable or 12V LED lights which you can connect to the socket of the Booster. Please
always recharge the Start Booster after use.
B.
BATTERYLESS START BOOSTER
1. Make sure the unit is fully charged and turned OFF (or that the voltage selector
for 12/24V units is disconnected).
2. Connect the positive (red) clamp to the positive terminal.
3. Connect the negative (black) clamp to the frame of the vehicle (ground).
4. If you have a 12/24V unit, choose the voltage with the voltage selector switch or
with the voltage connector plug 12V or 24V. If you have a 12V or 24V unit with
ON/OFF switch, turn it ON.
5. Then start your engine and stay clear of the battery and the Start Booster
while jump-starting. Make sure that it cannot fall inside the engine compartment.
6. Before removing the clamps, you can leave your unit on the engine/alternator
for 10-15 seconds
maximum
to allow the alternator to recharge your device.
7. Once started, first disconnect the negative clamp, then place the
voltage selector switch on OFF, or unplug the voltage connecter plug from
the 12/24V unit.
8. Then disconnect the red (positive) clamp and store them directly.
Note: It is normal that your Booster will get discharged quickly. It will also get
recharged very fast if you connect it to a battery (please see charging section).
C.
HYBRID START BOOSTER
1.
Connect the positive (red) clamp to the positive terminal.
2.
Connect the negative (black) clamp to the frame of the vehicle (ground).
3.
If you have a 12/24V unit, choose the voltage with the voltage selector switch or
with the voltage connector plug 12V or 24V. If you have a 12V or 24V unit with
ON/OFF switch, turn it ON.
4.
Then start your engine and stay clear of the battery and the Start Booster
while jump-starting. Make sure that it cannot fall inside the engine compartment.
5.
Before removing the clamps, you can leave your unit on the engine/alternator
for 10 seconds
maximum
to allow the alternator to recharge your device.
6.
Once started, first disconnect the negative clamp, then place the voltage
selector switch on OFF, or unplug the voltage connecter plug from
the 12/24V unit.
7.
Then disconnect the red (positive) clamp and store them directly.
Important: Should the vehicle refuse to start within 10 seconds, have your unit cool down for 3
minutes before the next attempt. If it still doesn’t start, please have
your car battery or engine checked. It may be that the car battery is defective
and refuses to accept the current from the Booster.
Содержание START BOOSTER 12/24V
Страница 51: ...NOTES 51...
Страница 52: ...L06201801...
