3
CHAPTER 2
Hardware Description and Connection
2.1
Hardware description
1. Camera switch : change the mode between Web Camera (USB) and IP
Camera
2. Connector and Interface : USB 1.1, RJ45 and Power adapter
3. Reset and Default :
a. Reset : When you change the mode between Web Cam and IP
Camera or set the IP Camera, you must reset (reboot) the
system
b. Default :
If you forget the IP address or ID Password, you can
Press ”Default” until the Ready LED is off.
original default parameters
c. Default IP address:
http://192.168.1.100
Default User ID: root
Default User Password: admin
4. The indicator LED :
a. Power LED : The light will be turned on, when you connect the power
supply to the Power connector.
b. Link LED : When IP Camera is connected to the network, this light will
be turned on.
c. 10/100 T Base LED : Check whether the network status is in high
speed or not.
4
d. Ready :
In IP Camera mode, after the ready LED is on about
40 ~ 50 seconds the IP Camera will be operational.
5. 6 infrared LEDs
and night-vision lens
2.2 First time configuring the IP Camera
For first time configuration, please connect IP Camera and your computer
as the following figure:
Step1 :
Change the switch to the mode
“
IP Camera
”
and reset the camera
Step2 :
Connect IP Camera and Computer with RJ45 Cable directly
Step3 :
When the LED is on and waiting for 40 ~ 50
seconds, then you must configuring the IP
address on your computer
IP Configuration
1. Access
Network settings
by clicking
Start =>
Settings =>
Control
Panel
2. Double click the
“Network”
and
“Dial-up Connections”
icon.
3. Double-click the
“Local Area Connection”
icon for the Ethernet
adapter,and click the
“Properties
”
button.
