Grand Design Imagine, Руководство пользователя

Страница: 92 / 180

90
Plumbing Systems
The bathing facilities in your RV function similar to those in
your home. Keep the water heater and holding tank capacities
in mind when using the fresh water system. The used water
will drain through the plumbing pipes into the grey water hold-
ing tank.
1. Be sure the water heater is ON and had sufficient time
to heat the water.
2. If dry camping, be sure your 12-volt water pump is ON.
3. Adjust the hot and cold faucets to the desired tempera-
ture before bathing.
4. To conserve water while showering, wet down and turn
the water OFF while you use soap, then rinse.
5. When you are finished, shut the water faucets OFF.
Unlike your home, the RV does not contain a water pressure
balance valve. If someone is using the shower, it is recom-
mended that the fresh water system NOT BE USED until they
are finished.
Maintenance
Refer to the manufacturer’s operator manual.
DRAINING THE FRESH WATER SYSTEM
The low-point drains valves release water in the supply lines
by opening the valves and all faucets. The water heater has
its own drain plug. To drain the permanent fresh water holding
tank and supply lines:
1. Open all faucets.
2. Open the fresh water holding drain valve.
3. Remove the caps from the “low point drains.”
4. Drain the sink by removing the drain cap.
5. Turn ON the water pump and allow it to run as needed.