Model 6010 Four Channel 20-bit Audio ADC
6010-5
INSTALLATION
Plug the 6010 module into any one of the ten slots in the frame and install the plastic
overlay provided onto the corresponding group of rear BNC connectors associated with the
module location. Note that the plastic overlay has an optional adhesive backing for
securing it to the frame. Use of the adhesive backing is only necessary if you would like
the location to be permanent and is not recommended if you need to change module
locations. This module may be hot-swapped (inserted or removed) without powering down
or disturbing performance of the other modules in the system.
CABLING
Refer to the backplane diagram of the module below for cabling instructions.
Connect an AES3id
reference input to the
Ref IN BNC if using an
external reference.
Connect output destina-
tions to the four sets of
AES Out 1/2 BNCs.
Connect the 15-pin high
density Audio In connector
to four analog audio sources.
Refer to the Audio In pinout
drawing below.
Connect output destina-
tions to the four sets of
AES Out 3/4 BNCs.
1
6
+
+
+
+
-
-
-
-
11
CH 2
CH 1
CH 3
CH 4
6010 Wiring to Frame
15-pin D Male Connector
Wiring Side-Male Plug
AUDIO IN PINOUT
