Graham Architectural Products
Homeowner’s Manual
Acoustical Aluminum Windows
20
Photo 46
Roller Housing Removal Screws
SERIES 0800
SLIDING GLASS DOOR
3.
Lower the panel as low as possible by adjusting panel rollers (see Adjusting Panel Rollers).
4.
Grasp both stiles and carefully raise panel into head pocket.
5.
With panel raised, pull bottom toward interior until the bottom sash rail is clear of track.
6.
With bottom rail clear of sill pocket, lower sash until it disengages the head pocket.
Fixed Panel Replacement
1.
Insert door panel top rail into exterior head pocket.
2.
With the head engaged, move panel into a vertical position.
3.
Lower sash into exterior track, slide sash to check proper alignment.
4.
Adjust rollers so panel is square with fixed jamb, and slide panel into the fixed jamb pocket.
5.
Attach the fixed panel retainer clip to fixed jamb using the previously removed screws and the
pre-drilled holes.
6.
Snap sill threshold into exterior track with slope to the exterior.
Replacing Panel Rollers:
1.
The wheel assembly may be replaced by first removing
the panel from frame and placing it on a suitable work
surface. The panel removal procedure is described above.
2.
To remove the wheel housing, simply remove the screw
located just above the roller adjustment screw and remove
the housing
(Photo 46)
.
3.
Insert the new wheel housing and align screw holes.
4.
Insert screw and tighten.
5.
Return the panel to the frame as described under panel
replacement.
Adjusting Lock and Strike Plate
1.
To adjust the reach of the lock catch, loosen the two set
screws located under the plastic cap in the lock
mechanism.
2.
Adjust the catch in or out as needed.
3.
To adjust strike plate, loosen the attachment screws and
slide the plate up or down as needed to align with lock
catch
(Photo 47)
.
Photo 47
Strike Plate Adjustment
Screws
