gmb / BA PowerGear_EN as of May 2015 / 29.10.2015
Page 6 of 23
PowerGear
gear units are in full compliance with the machine directives (EN 292) and EMC directives to the ex-
tent they are applicable.
4.2 Type designations
PowerGear P54 to P280
P version with type series L, H, FL, FH,
X version, reinforced, with type series L and H
Type series L
shown in ratio 2:1 and in Wa.2 (WA = shaft arrangement)
with 2 shaft ends on the output shaft. Additional shaft ar-
rangements are Wa.1 and Wa.3.
Fits on the shaft ends in k6
Type series H
shown in ratio 1:1, in Wa.2 (WA = shaft arrangement) with
fits in H7 at both shaft ends of the output shaft.
Fit on the drive shaft end in k6.
The bearings are provided as tapered roller bearings. The drive pinions are shrunk into the driven pinion gears on the shaft.
In the case of the
reinforced X version
the drive shafts are provided as pinion shafts.
PowerGear P360 to P450
P version with type series L and H
Type series L
Shown in ratio 1:1
The two bevel gears are connected to the shafts via feather
Type series L
Shown in ratio 3:1 (analogously 4:1 and 5:1)
complete with bevel gear on hub and pinion shaft.
