Grady-White Boats EXPRESS 360, Руководство пользователя, Страница: 84 / 136

3 6 0 E
X P R E S S
8–18
Freezer/Refrigerated Box System
The aft fishbox and port cockpit insulated coolers are also refrigerated. The cockpit coolers
switch on the AC panel must be on to cool these boxes. It is not required to have the air/cooler
pump switch on and the air condition seacock open to cool these boxes, but it is
recommended. The raw water moving through the system will allow the refrigeration unit to
cool the boxes more efficiently. If you choose to turn the air/cooler pump on, ensure the air
condition seacock is open. Refer to
“Air Condition & Cockpit Coolers One-Line Diagram”
on page 8–58 for wiring detail.
These boxes may be used as freezers or refrigerators by designating the set point temperature
for each box. The set points for each box are set using the digital temperature switches in the
cooler control panel located in the galley area near the cabin door. To establish the set point,
first press set — SP text will appear on the display. Press set again — the value will appear on
the display. Change the temperature set point to the desired value using the up and down
arrows. Press set when the desired set point is displayed to enter this value. Press set and down
simultaneously to exit programming or wait one minute and the switch will exit programming
mode automatically. Please reference the owner’s manual for this system included in the
owner’s packet for more detailed information.
Helm Air Conditioner
The helm air conditioning system operates on AC power only; therefore, the generator or
dockside power must be in use with load group 2 energized. The helm air conditioner switch
on the AC/DC panel activates the unit’s control pad located in the galley area near the cabin
door. The air/cooler pump switch must also be on and the air conditioner seacock must be
open to supply the unit with raw water. The thermostatic control is similar to household units.
Supply vents are located in the port deckwing insert and beneath the port bench seat on the
inboard side. The return vent is located beneath the port bench seat on the forward side. The
helm air conditioning unit is located beneath the port bench seat. The condensation drain for
the unit drains to the shower sump. Therefore, the shower sump pump should be switched on
when using the air conditioner to remove any condensation. Refer to the Operation and
Maintenance manual in your Owner’s Packet for specific instructions on using the unit. See
“Helm Air Conditioning Layout” on page 8–31 for a layout of the helm air conditioning
system. See “Air Condition & Cockpit Coolers One-Line Diagram” on page 8–58 for a
wiring diagram.
N O T I C E
If your boat is removed from the water, leaving the seacock open will drain the water in the helm
air conditioning system. This may cause an airlock in the air conditioner water pump in
subsequent operation. To prevent this drainage, close the air conditioner seacock. If the boat is
being winterized, leave the seacock open so the water can drain. Then, remove any remaining
water by blowing pressurized air through the system. See the Operation and Maintenance
Manual included in your Owner’s Packet for additional winterizing information.