Grady-White Boats Canyon 456, Руководство пользователя

Страница: 75 / 90

8-15
Chapter 8: Canyon 456
W A R N I N G
End-of-Life (EOL)
The carbon monoxide detector is powered by a dedicated, sealed lithium ion battery, and is not
user serviceable. The permanent battery is made to last the life of the unit, approximately 7
years. When the unit reaches EOL status it will no longer flash any indicator lights and there
will be an audible beep once every 60 seconds, indicating the entire carbon monoxide detector
should be replaced.
Cockpit Freshwater Showers
There are two cockpit showers, one on the aft starboard gunwale and one on the forward port
gunwale� Before using the cockpit showers, the “Freshwater” switch must be on in CZone� Open the
cover and pull the shower wand from the recessed deck fitting� Depress the button on the back of
the wand to spray water� To reinstall the shower wand, pull up slightly on the hose and then let the
spring loaded unit retract the hose until the wand is back in the recessed deck fitting� To supply hot
water to the aft cockpit shower, make sure the hot water heater is on and then adjust the knob
directly aft of the cockpit shower recess to adjust the temperature�
Compass
The compass is located at the helm station in direct view of the operator when navigating the
boat� Follow the compass instructions included in your Owner’s Packet to make compensation
adjustments�
Cockpit Cooler System
The aft fishbox can be used as a refrigerator or a freezer� The “Cockpit Cooler” switch on the
CZone panel must be “on” to cool this box� The raw water moving through the system will allow the
refrigeration unit to cool the box more efficiently�
The temperature of this box is determined by designating the set point temperature� Establish
the set point using the digital temperature switch in the cooler control panel located on the insert
panel on the port side of companionway� To establish the set point, first press and hold SET — “SET”
will appear on the display and then the current value will appear on the display� Change the
temperature set point to the desired value using the up and down arrows� Press set again when the
desired set point is displayed to enter this value�
Downrigger Outlets
There is a 12V power supply under the gunnel that can be utilized for electric reels or electric
downriggers� A 60A breaker for overcurrent protection is located on the forward wall of the aft
rigging area� If you do not have power to your receptacle, make sure that the breaker is not tripped�