GRADEN SWING-WING SW04, Руководство пользователя

Страница: 13 / 28

4. Assembly Instructions
Your Verticutter has been manufactured, assembled and tested at Graden
Industries before being shipped.
Depending on your local distributor, your Verticutter may have been partially
disassembled prior to dispatch. Your machine may be received in the following
condition :

Left and Right wheel axle assemblies bolted in reverse mounting position (for
packing purposes only)

Castor wheels removed from supports
 Left and Right Hand Uprights removed
 Crossbar removed
 P.T.O shaft (supplied separate)
As appropriate, please carry out the following assembly instructions.
Tools required : ½ inch AF spanner (x2)
9
/
16
inch AF spanner (x2)
¾ inch AF spanner (x2)
15
/
16
inch AF spanner (x2)
Large Adjustable spanner
Steps
1. Remove all packaging material.
2. Ensure that all documents are present. With each machine should be this
manual, and a manual for the PTO Shaft (this may still be attached to the PTO
Shaft).
3. Unscrew the stands from the pallet and remove the machine from the pallet.
4. Attach the Castor Wheels (5299) to the front (0622) and rear (0624) stands with
the bolts supplied (use ½ inch AF spanners).
5. Attach Height Connecting Rod (1119) to Rear Wheel Axle (1114), (use
15
/
16
inch
AF spanners), ensuring the Retaining Chain (1151) is hanging beneath the
Height Connecting Rod (1119).
6. Attach the Left and Right Hand Wheel Axle Assemblies (1115 & 1116) to their
respective Rotor Housings (1111 & 1112) with the bolts supplied as shown in
Diagram Three (use
9
/
16
inch AF spanners).
7. Attach the Left and Right Hand Uprights to the Swing-Wing Frame (use ¾ inch
AF spanners and large adjustable spanner) with the bolts supplied, but do not
tighten them up completely.
8. Fit the Crossbar (1118) to the Uprights (1096 & 1097), getting all four bolt and nut
sets started in the holes, (use
9
/
16
inch AF spanners), but before final tightening
of these bolts, tighten up all the bolts for the Uprights (1096/1097) to the Swing-
Wing Frame (1110). Now tighten the Crossbar (1118) bolts completely.
Your machine should now be assembled and ready to use.