Securing
Securing
Securing the
the
the Drum
Drum
Drum Cover
Cover
Cover
The drum cover must be secured to the drum
to ensure proper clearance of rotating parts
and prevent vibration. If using the drum
cover without an elevator, the cover must be
secured by clamping or other means. For
open-headed drums with closing ring, make
sure the lever-lock or closing bolt is fastened
securely before operating.
Using
Using
Using aa
a Custom
Custom
Custom Drum
Drum
Drum Cover
Cover
Cover
If the Xtreme-Duty agitator is being mounted on
a custom drum cover, sufficient clearance must
be provided around any moving parts. See the
image below for the hole mounting pattern and
minimum clearance required.
Attaching
Attaching
Attaching the
the
the Blades
Blades
Blades
1. Slide the agitator blade assembly (B1) onto
the shaft (C1), positioned so that the blade
coupling screws (B2) will contact the flats of
the shaft. Apply thread sealant (supplied
with the blades) to screws (B2).
2. Adjust the height of the blade assembly as
desired and tighten two screws (B2) to attach
the blades onto the shaft. Tighten to 13
ft-lb (17.6 N
•
m).
3. Apply thread sealant to screw (C3) and
tighten to 12–20 in-lb (1.3–2.3 N
•
m).
4. Slide the shaft coupler (C2) onto the output
shaft of the agitator drive (A1) up to the mid
point of the coupler screws. Tighten to 15
ft-lb (20 N
•
m).
5. Slide the blade shaft (C1) into the coupler
and tighten two screws to attach the shaft to
the coupler. Tighten to 15 ft-lb (20 N
•
m).
10
3A4032D
