Graco ThermoLazer, Операция

Страница: 15 / 40

Important Safety Information
3A1319K 15
Important Safety Information
BEFORE LIGHTING: Smell all around the working area
for gas. Be sure to smell next to the ground because
propane is heavier than air and will settle on the ground.
DAILY: Check for gas leaks. Use mild soap and water
solution or other approved method. Apply solution to all
gas lines and fittings then watch for gas bubbles.
Front Screed Box Burners and Rear Screed Box Burn-
ers will need to be ignited to test gas lines and fitting
downstream of flame adjusting valve.
NOTE: Kettle burners will need to be ignited to test gas
lines and fittings downstream of gas safety valves (CC).
Ignite burners and torch only after thoroughly checking
gas line and fittings.
WHAT TO DO IF YOU SMELL GAS OR FIND GAS
BUBBLES:
• Evacuate all unqualified personnel from area
• Do not try to ignite any burner
• Do not strike a flame
• Do not use electric fans to remove gas from area
• Do not touch any electric switch and do not use
any phone
• If leak is from a gas fitting, tighten fitting until leak
stops
• If leak is from a gas line, shut off at LP-gas cylin-
der and replace gas line
• Immediately call your gas supplier from a remote
phone. Follow gas supplier’s instructions.
• If leak can not be stopped by shutting off LP-gas
cylinder shut-off valve, immediately call your gas
supplier from a remote phone. Follow gas sup-
plier’s instructions.
• If you cannot reach your gas supplier call the fire
department
Use only your hand to push in or turn the kettle gas
safety valve (CC). Never use tools. If the knob will not
push in or turn by hand, do not try to repair it; call a qual-
ified service technician. Attempted repair or force may
result in a fire or explosion.
Do not use this equipment if any part has been under
water. Immediately call a qualified service technician to
inspect equipment and all components. Replace defec-
tive parts only with approved manufactured parts.
If you do not follow these instructions exactly, a fire
or explosion may result causing property damage,
personal injury or death.
ti16842b
ti16832b
ti25698a
ti14128a
ThermoLazer 300
TC
/ProMelt shown above