Graco ThermoLazer 257500, Операция

Страница: 10 / 24

Lighting Instructions
10 313787C
Lighting Instructions
Lighting Kettle Burners
Read For Your Safety, page 7.
1. Turn temperature control knob (AA) to 0 (“OFF”).
2. Turn kettle gas safety valve (CC) to “OFF”.
3. Open burner view port.
4. Open manual shut-off valve on propane tank
located at front of unit; open kettle manual shut-off
valve (KK) below kettle and behind propane tank.
5. Turn gas safety valve (CC) to “PILOT”.
6. Push in gas safety valve knob.
7. Push kettle pilot burner igniter (DD) until pilot
ignites.
8. Continue to push in gas safety valve (CC) in for
approximately 1 minute. If pilot goes out, repeat
steps 4-6 after 10 minutes.
9. Turn gas safety valve knob to “ON”.
10. Turn temperature to 250° F (121° C) and observe
that main burners have ignited. Turn kettle tempera-
ture control back to “0” and observe that main burn-
ers shut off.
11. Close burner view port.
12. Turn temperature control to desired setting.
Shutting Off Burner
1. Turn gas safety valve to “OFF”.
2. Close manual shut-off valve on propane tank. Close
kettle manual shut-off valve (KK) when finished
heating with kettle burners.
NOTE: The kettle gas burner can be lit manually with a
small torch (for example: DOT 39 NRC 228/286 Cylinder
with #3 torch tip) if the battery powered pulse ignitor fails
to light the pilot.
ti14124a
AA
ti14131a
CC
ti14130a
ti14127a
ti14129a
KK
ti14131a
DD
CC
If pilot ignites without depressing the gas safety valve
knob, replace gas safety valve. If gas safety valve
knob does not pop back after releasing in pilot posi-
tion, STOP and replace gas safety valve. Shut off gas
at propane tank before replacing valve.
If main burners do not ignite or shut off when rotating
temperature control knob, STOP. Shut off gas at the
propane tank. Follow diagnostic procedure in Repair
manual.
ti14128a
ti14125a
KK