Operation
18
309832D
Dispensing material
Adjusting timers and controllers
See Timer manual 310814 for instruction. See Air Saver
Control instructions in appropriate applicator manual.
•
310801 Manual Applicator manual
•
310803 Automatic Applicator manual
Do not operate hot melt unit until material in tank is
at set temperature. The pump will not operate until
the tank is within 90% of set temperature. The tank
is at temperature when all device LEDs are flashing
GREEN.
1.
Adjust panel controls, see
2.
When device indicators are flashing green, set
pump function. See
•
The normal mode of pump operation is the
cycle mode.
•
When setting pump speed for DC motors, set
the pump speed to the lowest necessary
speed. This will maintain operating fluid pres-
sure and reduce the potential for glue degrada-
tion due to shearing in the pump.
3.
Dispense the material as instructed in appropriate
applicator manual.
4.
To adjust flow of material, turn the pressure regula-
tor (Q), using a 10 mm hex wrench.
•
To increase flow, turn regulator clockwise.
•
To decrease flow, turn regulator counterclock-
wise.
Q
Increase flow
Decrease flow
Содержание THERM-O-FLOW T7 Series
Страница 36: ...Parts 36 309832D Parts Housing assembly 1 2 3 4 5 7 6 8 ti5398a 8 10 9 13 12 11 14 15 16 17 ...
Страница 41: ...Parts 309832D 41 ...
Страница 46: ...Schematics 46 309832D Base wiring ...
Страница 49: ...Technical Data 309832D 49 ...