Graco Therm-O-Flow 20, Инструкция - Каталог запасных частей

Страница: 4 / 66

Manual Conventions
4 309858K
WARNING
SKIN INJECTION HAZARD
High-pressure fluid from gun, hose leaks, or ruptured components will pierce skin. This may look like just
a cut, but it is a serious injury that can result in amputation. Get immediate surgical treatment.
•
Do not point the gun at anyone or at any part of the body.
• Do not put your hand or fingers over the gun fluid nozzle.
• Do not stop or deflect leaks with your hand, body, glove, or rag.
• Do not “blow back” fluid; this is not an air spray system.
• Follow Pressure Relief Procedure in this manual, when you stop spraying and before cleaning,
checking, or servicing equipment.
• Use lowest possible pressure when flushing, priming, or troubleshooting.
• Engage trigger lock when not spraying.
• Tighten all fluid connections before operating the equipment.
• Check hoses, tubes, and couplings daily. Replace worn or damaged parts immediately. High pres-
sure hose cannot be recoupled; replace the entire hose.
FIRE AND EXPLOSION HAZARD
Flammable fumes, such as solvent and paint fumes, in work area* can ignite or explode. To help prevent
fire and explosion:
•
Use equipment only in well ventilated area.
• Eliminate all ignition sources; such as pilot lights, cigarettes and plastic drop cloths (potential static
arc).
• Do not plug or unplug power cords or turn lights on or off when flammable fumes are present.
• Keep work area free of debris, including solvent, rags and gasoline.
• Ground equipment and conductive objects. See Grounding.
• Hold gun firmly to side of grounded pail when triggering into pail.
• Use only grounded hoses.
• If there is static sparking or you feel a shock, stop operation immediately. Do not use equipment
until you identify and correct the problem.
ELECTRIC SHOCK HAZARD
Improper grounding, setup, or usage of the system can cause electric shock.
•
All electrical wiring must be done by a qualified electrician and comply with all local codes and regu-
lations.
• Connect only to grounded power source.
• Turn off and disconnect power at main switch before disconnecting any cables and before servicing
equipment.
BURN HAZARD
This equipment is used with heated fluid, which can cause equipment surfaces to become very hot. To
avoid severe burns:
•
Do not touch hot fluid or equipment.
• Allow equipment to cool completely before touching it.
MOVING PARTS HAZARD
Moving parts can pinch or amputate fingers and other body parts. Pressurized equipment can start acci-
dentally and cause serious injury.
•
Keep clear of moving parts.
• Do not operate equipment with protective guards or covers removed.
• Before checking or servicing equipment, follow the Pressure Relief Procedure in this manual. Dis-
connect power or air supply.
• Do not move or lift pressurized equipment.