Graco Therm-O-Flow 194485, Инструкция-перечень запасных частей

Страница: 3 / 48

310538 3
Warnings
The following Warnings are for the safe setup, use, grounding, maintenance, and repair of this equipment. The
exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure–specific risks.
Refer back to these Warnings. Additional product–specific warnings may be found throughout the body of this
manual where applicable.
WARNING
INSTRUCTIONS
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture, malfunction, or start unexpectedly and
result in serious injury.
D
This equipment is for professional use only.
D
Read all instruction manuals, warnings, tags, and labels before operating the equipment.
D
Use the equipment only for its intended purpose. If you are uncertain, call your Graco distribu-
tor.
D
Do not alter or modify this equipment. Use only genuine Graco parts and accessories.
D
Check the equipment daily. Repair or replace worn or damaged parts immediately.
D
Do not exceed the maximum air working pressure of 1 MPa (10 bar, 150 psi) to the applicator.
D
Do not exceed the maximum fluid working pressure of 24 MPa (241 bar, 3500 psi) to the
applicator or manifold.
D
Never exceed the recommended working pressure or the maximum air inlet pressure stated on
your pump or in the Technical Data on page 47.
D
Be sure that all spray/dispensing equipment and accessories are rated to withstand the maxi-
mum working pressure of the pump. Do not exceed the maximum working pressure of any
component or accessory used in the system.
D
Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces.
D
Do not expose Graco standard hoses to temperatures above 180
_
F (82
_
C) or below –40
_
F
(–40
_
C). Do not expose Graco electrically heated hoses to temperatures above 400
°
F
(222
°
C) or below –40
_
F (–40
_
C).
D
Do not expose Graco standard hoses to temperatures above 180
_
F (82
_
C) or below –40
_
F
(–40
_
C).
D
Do not use the hoses to pull the equipment.
D
Use only fluids and solvents that are compatible with the equipment wetted parts. See the
Technical Data sections of all the equipment manuals. Read the fluid manufacturer’s warnings.
D
Always wear protective eyewear, gloves, clothing, and respirator as recommended by the fluid
and solvent manufacturers.
D
Wear hearing protection when operating this equipment.
D
Comply with all applicable local, state and national fire, electrical and other safety regulations.