Installation
Installation
Installation
General
General
General Information
Information
Information
The Typical Installation shown is only a guide for
selecting and installing system components.
Reference letters in the text, for example (A), refer to
the callouts in the figures.
The Pail Unloader System consists of parts which are
stationary and parts attached to the air cylinder piston
rod. The parts, such as the pump and the control
assembly, attached to the air cylinder center shaft
will raise and lower (move) during normal operation.
These moving parts comprise the ram.
Locate
Locate
Locate the
the
the Pump
Pump
Pump System
System
System
1.
Position the pump system so the air controls are
easily accessible. Ensure that there is enough
space overhead for the ram to raise fully. (See
2.
Make sure the surface is flat and that the unit
doesn’t wobble.
NOTE:
NOTE:
NOTE: If the unit is being located in a permanent
location, use the four holes in the baseplate as a
guide to locate where to drill holes for mounting
anchors.
3.
For ease of operation and service, locate the
pump so fluid outlet port is easily accessible.
NOTE:
NOTE:
NOTE: The outlet can be rotated to accommodate
the location.
NOTE:
NOTE:
NOTE: An area should be left clear around the
unit to ensure safe access for maintenance.
System
System
System Components
Components
Components
B
Air Motor
C
Displacement Pump
D
Platen
G
Integrated Air Control
J
Platen Bleed Port
K
Blowoff Port
L
Platen to pump lower clamp
Required
Required
Required Accessories/Components
Accessories/Components
Accessories/Components Not
Not
Not Supplied
Supplied
Supplied
S
Fluid Line
T
Air Supply Line
U
Air Line Drain Valve
V
Air Filter
W
Bleed Type Air Shutoff Valve
Fig.
Fig.
Fig. 1
1
1 Typical installation
6
3A5400B
Tel: 866-777-6060
Fax: 866-777-6383
Springer Pumps, LLC
Website: www.springerpumps.com
Int'l: +001 267 404 2910
