10 307929
Installation
Installing Circulating Kit 222436
WARNING
Before installing the heater, heater mounting kit
and circulating kit, follow the
Pressure Relief
Procedure
on page 14. Disconnect all hoses from
the pump.
NOTE:
Reference numbers marked with a symbol (for
example, 77
), are included in kit 222436.
Apply 110110 pipe sealant (included in the kit) to all
male threads, except at swiveling connections.
1.
Unscrew the suction hose (22) from the pump
intake elbow (21) and set the hose aside. Remove
the elbow (21) from the pump intake and discard.
See Fig. 3.
2.
Screw the rigid end of the manifold (77
) onto the
pump intake, and attach the suction hose (22) to
the swivel end of the manifold. See Fig. 5.
3.
Place a washer (81
) and insulator (82
) on each
of the screws (38
). Insert the screws through the
mounting holes on the left side of the pump sup-
port bracket (J), working from the inside. Place
another insulator (82
) on each of the screws on
the outside of the bracket. Use the screws to
attach the back pressure regulator (83
) to the
pump support bracket.
4.
Screw one of the nipples (41
) into the outlet in
the base of the back pressure regulator (83
), then
screw one of the elbows (40
) onto the nipple so
the male end of the elbow faces forward. Install
another elbow (40
) in the inlet of the back pres-
sure regulator, then install the other nipple (41
) in
the elbow. Install plugs in the other regulator
ports.
5.
Screw an elbow (40
) into the open port of the
pump fluid intake manifold (77
), so the female
end of the elbow faces left. Install the CIRC end of
the three-way ball valve (78
) in the elbow, so the
valve handle is at the front.
6.
Screw a second elbow (40
) onto the IN branch of
the three-way valve (78
), so the elbow points
upward. Connect one end of the hose (80
) to this
elbow, and the other end to the nipple (41
) at the
outlet of the back pressure regulator.
7.
Connect the drain hose (79
) to the DRAIN end of
the three-way valve (78
).
8.
Connect the fluid return line to the nipple (41
) at
the inlet of the back pressure regulator.
9.
Connect the air and fluid hoses and gun as ex-
plained on page 6.
0975B
Fig. 6
1
2
29
30
N
Q
T
S
R
P
M
L
M
N
31
Connect air hose for first gun here
Air Regulator Connections for a Two-Gun System (All Models)
Connect air hose for second gun here
1
2
Содержание Ratio Monark Hydra-Spray Series
Страница 22: ...22 307929 Notes...
