Graco Pro 270GS, Операция

Страница: 10 / 28

Setup
10 3A2818A
Prime and Flush Storage Fluid
Before you use your sprayer for the first time or begin a
new spraying project, you need to prime the sprayer and
flush the storage fluid out of the sprayer.
Oil- or Water-based Materials
• When spraying water-based materials, flush the
system thoroughly with water.
• When spraying oil-based materials, flush the sys-
tem thoroughly with mineral spirits or compatible,
oil-based flushing solvent.
• To spray water-based materials after spraying
oil-based materials, flush the system thoroughly
with water first. The water flowing out of prime tube
should be clear and solvent-free
before you begin
spraying the water-based material.
• To spray oil-based materials after spraying
water-based materials, flush the system thoroughly
with mineral spirits or a compatible oil-based flush-
ing solvent first. The solvent flowing out of the prime
tube should not contain any water.
• When flushing with solvents, ground pail and gun.
Read Grounding Requirements, page 7.
• To avoid fluid splashing back on your skin or into
your eyes, always aim gun at inside wall of pail.
Engine Preparation
NOTE: Refer to Engine Owner’s Manual for detailed
safety, operation and service information.
1. Check engine oil level. Add SAE 10W-30 (summer)
or 5W-30 (winter), if necessary.
2. Fill fuel tank.
3. Attach spray grounding clamp to earth ground.
(cold)
ti5952a
ti5953a
ti5954a