Graco King 236462, Инструкция-перечень запасных частей

Страница: 19 / 30

308352 19
Displacement Pump Service
15. Screw the intake cylinder (19) into the intake
housing (17). Using a pipe wrench on the hex of
the cylinder (19), torque the cylinder to 522–542
N.m (385–400 ft-lb). This will also torque the intake
valve housing (17) and pump cylinder (10) into the
outlet housing (9). See Fig. 14.
16. Screw the bleeder valve plug (20) into the valve
body (29). The plug has two sets of threads. When
reassembling, be sure to screw the plug complete-
ly into the valve body. See Fig. 13.
17. Check that the flats of the priming piston rod (18)
are accessible below the intake cylinder (19). If
not, tap on the top of the displacement rod (1) with
a rubber mallet, until the flats are exposed.
18. Slide the priming piston (21) onto the rod (18) until
it stops. Hold the rod (18) steady with an adjust-
able wrench on the flats, and screw the seat (22)
onto the rod with another wrench. Torque to 75–88
N.m (55–65 ft-lb). See Fig. 14.
19. Reconnect the displacement pump to the air motor
as explained on page 12.
03829
2
9
18
22
21
19
17
10
Fig. 14
1
2
Torque to 522–542 N.m (385–400 ft-lb).
2
1
Torque to 75–88 N.m (55–65 ft-lb).
1