Graco FinishPro II 395, Руководство пользователя

Страница: 12 / 42

General Repair Information
12 333126A
General Repair Information
• Keep all screws, nuts, washers, gaskets, and elec-
trical fittings removed during repair procedures.
These parts usually are not provided with replace-
ment kits.
• Test repairs after problems are corrected. If sprayer
does not operate properly, review repair procedure
to verify you did it correctly. See
Troubleshooting ,
page 13.
• Overspray may build up in the air passages.
Remove any overspray and residue from air pas-
sages and openings in the enclosures whenever
you service sprayer.
• Do not operate sprayer without motor shroud in place.
Replace if damaged. Motor shroud directs cooling air
around motor to prevent overheating.
Flammable materials spilled on hot, bare, motor could
cause fire or explosion. To reduce risk of burns, fire or
explosion, do not operate sprayer with cover removed.
To reduce risk of serious injury, including electric shock:
•
Do not touch moving or electric parts with fingers or
tools while testing repair.
•
Unplug sprayer when power is not required for testing.
•
Install all covers, gaskets, screws and washers before
you operate sprayer.
NOTICE
•
Do not run sprayer dry for more than 30 seconds. Doing
so could damage pump packings.
•
Protect the internal drive parts of this sprayer from water.
Openings in the cover allow for air cooling of the
mechanical parts and electronics inside. If water gets in
these openings, the sprayer could malfunction or be per-
manently damaged.
•
Prevent pump corrosion and damage from freezing.
Never leave water or water-base paint in sprayer in cold
weather. Freezing fluids can seriously damage sprayer.
Store sprayer with Pump Armor to protect sprayer during
storage.
•
Do not allow material to dry on gun air cap. Poor spray
finish could result.