9.
Remove the check balls (22), d-rings (21), and
wearable seats (19) from the outlet side of each
fluid cover (6).
10. Remove the nuts (28) and bolts (24) by using two
10 mm wrenches, to hold on one side and to turn
the other. The nuts (28) will come off of one side
only. Remove the bolts (24).
NOTE:
NOTE:
NOTE: The nuts are permanently affixed to one
end of the bolts.
11. Remove the fluid cover retainers (9) and the fluid
covers (6) from the body (1).
Disassemble
Disassemble
Disassemble the
the
the Center
Center
Center Section
Section
Section
1.
One diaphragm (25) and strike plate (4) should
screw off by hand. Slide the second diaphragm
and strike plate out with the shaft (5).
2.
Inspect the o-ring seals (32) and glide shaft seals
(39). Replace as needed.
3.
Carefully remove the cap plugs (37) from both
muffler locations.
4.
Use a 4 mm Allen wrench to remove the screws
(16) and muffler caps (14).
5.
Inspect the mesh baffle spacers (38) and felt
mufflers (15). Replace as needed.
6.
Use a 19 mm socket and the supplied tool (42) to
remove the spool assembly (3).
7.
Inspect each spool assembly (3) for worn or
damaged parts. Replace each assembly as
needed.
Replace
Replace
Replace the
the
the Air
Air
Air Motor
Motor
Motor
1.
Use pin wrench (43) to remove the air motor
assembly (2) from the body (1).
2.
Inspect o-rings (33) & (34), and replace if
necessary.
334794F
19
Tel: 866-777-6060
Fax: 866-777-6383
Springer Pumps, LLC
Website: www.springerpumps.com
Int'l: +001 267 404 2910
