Graco AquaMax 804594 A Series, Инструкция-перечень запасных частей

Страница: 4 / 22

4
309016
Setup
Fig. 1
high-pressure hose
connection
hose
rack
3/4 in. garden
hose connection
for water inlet
spray
gun
hose
9259A
pump
pressure gauge
Check for Shipping Damage
Check the unit for any damage that could have
occurred during shipping.
Notify the carrier
immediately if there is any damage.
Setup
Connect the high-pressure hose between the pump
outlet and the gun inlet. Both of these connections are
made with quick couplers.
CAUTION
Up to 100 ft (30 m) of high-pressure hose may
be used. Longer hoses might affect pressure
washer performance and chemical injector
performance.
Install the appropriate spray tip on the wand. See
Installing and Changing Spray T ips on page 7. If
you are using a sandblaster kit, see its separate
manual for installation instructions.
Connect to Water Supply
CAUTION
Before you connect to the water supply, check your
local plumbing code regarding cross-connection to
the water supply. A backflow preventer, Part No.
801133, is available to prevent backflow of
contaminated water into the fresh water supply.
Install it upstream from the pump.
If inlet water pressure is over 414 kPa, 4.1 bar
(60 psi), a regulating water valve, Part No. 800258,
must be installed at the garden hose connection.
Do not exceed 70
_ C (160 _ F) inlet water
temperature.
Connect a hose with at least a 3/4 in. (19 mm) ID from
the water supply to the unit’s 3/4 in. garden hose inlet.
The supply hose should not be more than 50 ft (15 m)
long.
NOTE: The water source at the unit must have a
minimum flow rate equal to that of the unit. See
Technical Data on page 21.