Graco 333586E, Руководство по установке

Страница: 50 / 102

Repair
50 333586E
Connect Platen
55 Gallon Platen
1. Place o-ring (428) from mounting kit on the Platen
(AD). If attached to plate, place Displacement Pump
(AC) onto Platen (AD). See F
IG
. 43.
2. Secure Pump’s intake flange to plate with screws
(426), washers (425), and clamps (427) included in
mounting kit 255392.
20 Liter Platen
NOTE: Before installing the 20, 30, or 60 liter Platen to a
Pump with an intake adapter, install adapter and o-ring
from mounting kit using the two set screws. See F
IG
. 44.
1. Place o-ring (463) from mounting kit on Pump
intake. Loosen the Pump intake flange screws (462)
and carefully lower Pump onto o-ring (463) and
Platen.
2. Secure Pump’s intake flange to plate with screws
(462).
Remove Wipers
See Remove and Reinstall Wipers on page 44.
Install Wipers
See Remove and Reinstall Wipers on page 44.
Remove Displacement Pump
The procedure for removing the Displacement Pump
(AC) depends on which Driver (AB) and Platen (AD) the
unit uses. Find your Ram Assembly (AA), Driver (AB),
and Platen (AD) below to remove the Displacement
Pump (AC). Refer to your Displacement Pump manual
to repair the Displacement Pump.
If the Driver does not require servicing, leave it attached
to its mounting. If the Driver does need to be removed,
see
Remove Driver on page 52.
D200 3 in. and D200s 6.5 in. Ram Supply
Units
1. Follow the Pressure Relief Procedure on page 39.
2. Turn off power to the ram:
a. If using an ambient Single Ram Supply System,
turn the red Disconnect Switch (AZ) OFF.
b. If using a heated Single Ram Supply System,
turn the red Disconnect Switch (AZ) OFF.
c. If using an ambient Tandem Ram Supply
System, turn the red Disconnect Switch (AZ)
OFF on the Ram Supply Unit that requires
repair only.
d. If using a heated Tandem Ram Supply System,
turn the red Disconnect Switch (AZ) OFF on the
Ram Supply Unit that requires repair only.
3. See Disconnect Displacement Pump in your
Pump package manual.
4. Open the Main Air Slider Valve (BA).