Graco 333586E, Руководство по установке

Страница: 31 / 102

Setup
333586E 31
10. If two hoses are used, connect Supply Hose 2 (D) to
the Swivel Fitting (H) on the Dispense Valve (B)
using the Supply Hose 2 to Swivel Fitting (G). If only
one hose is used, connect Supply Hose 1 (C) to the
Swivel Fitting (H) on the Dispense Valve (B) using
the Supply Hose 2 to Swivel Fitting (G).
11. Tighten all fittings until secure.
12. Connect the Air Line (AR) (not supplied) to the air
fitting (FT) on the dispense valve solenoid. See the
iQ Dispense Valves Instructions-Parts manual. See
F
IG
. 31.
Electrical Connections
Pressure Transducer
1. If using a Single iQ Ram Supply System, connect
the pressure transducer cable (PC) from dispense
valve (B) to Port 6 on the Electric Driver (AB). See
Electric Driver Communication Connections for
Single Rams on page 18.
2. If using a Tandem iQ Ram Supply System:
a. Connect the Pressure Transducer Cable (PC)
from the Dispense Valve (B) to the Tandem
Block Valve Pressure Transducer Splitter. See
F
IG
. 29.
b. Connect one male end of the M12 5 pin
Pressure Transducer Splitter cable (ZZ) on the
Tandem Block (R) to Port 6 on the Electric
Driver (AB) on Ram 1. The second male end
goes to Port 6 on Ram 2. See
Electric Driver
Communication Connections for Tandem
Ram s on page 19.
F
IG
. 28
B
H
G
D
PC
F
IG
. 29
PC
Pressure Transducer Cable
Connection (XX).
Discrete Robot Cable
Connection (SS).
Dispense Valve solenoid
Cable Connection (YY).
M12 8 pin Discrete Robot
Splitter (RR).
M8 4 Pin Dispense Valve
Solenoid Splitter (TT) to
Splitter Attached to Port 4
on Electric Drive (AB) on
Ram 1 and Ram 2. Pin
M12 5 Pin Pressure
Transducer Splitter
Cable (ZZ) to Port 6
on Electric Drive
(AB) on Ram 1 and
Ram 2..
R
(NN)