Installation
14
333013B
Install the Gun
1.
Loosen the manifold’s two set screws (29) and slide
the manifold (20) onto a 1/2 in. (13 mm) mounting
rod.
2.
Position the gun and tighten the two set screws.
NOTE:
For added positioning reliability, insert a 1/8 in.
(3 mm) locating pin into the slot (NN) in the bracket and
through a hole in the rod. See the detail in F
IGURE
4.
Install the Pro Xp Auto Control
Module
The Pro Xp Auto Control Module is required for use with
smart models. To install a Pro Xp Auto Control Module,
see the module instruction manual 332989.
Connect the Air Line
F
IGURE
3 shows a schematic of air line connections, and
5 shows the manifold connections. Connect the
air lines as instructed.
1.
Connect the Graco Grounded Turbine Air Hose (B)
to the gun's turbine air inlet (TA) and connect the
hose ground wire (A) to a true earth ground (N). The
gun turbine air inlet fitting has left-hand threads to
prevent connecting another type of air hose to the
turbine air inlet. See
, on page 57 for
further information about the hose.
2.
Check the electrical grounding of the gun as
instructed on page 19.
Ground the Cabinet
Connect the main ground wire (V) to a true earth
ground.
F
IG
. 4 Mounting Bracket
To reduce the risk of a fire, explosion, or electric
shock, the Graco Grounded Turbine Air Hose must
be interlocked with:
• The isolation system to shut off the turbine air
supply anytime the enclosure is opened or
entered.
• The ventilators to prevent operation of the power
supply unless the ventilating fans are on.
20
NN
8.18 in.
(207.7 mm)
To
2.88 in.
(73.2 mm)
nozzle tip
29
To reduce the risk of electric shock or other serious
injury, the red-colored Graco Grounded Turbine Air
Hose must be used for the turbine air supply hose,
and the hose ground wire must be connected to a
true earth ground. Do not use the black or
gray-colored Graco air hoses.
