Graco 25E079, Операция

Страница: 22 / 52

Driver Troubleshooting
22 3A5379B
8 Alarm Encoder Error
• Cycle the power and check the status indicator to see if the error is
still active.
• Verify that the encoder cable is connected securely.
• The encoder may need to be replaced.
• Contact your Graco distributor or Tech Service for more informa
-
tion.
9 Alarm Software Versions Do Not Match
• Obtain the software update token and follow Software Update
Procedure on page 30
(contact your Graco distributor or Tech Service for more informa
-
tion).
10 Alarm Circuit Board Communication Failure
• Cycle the power and check the status indicator to see if the error is
still active.
• Contact your Graco distributor or Tech Service for more informa
-
tion.
11 Alarm Internal Circuit Board Hardware Failure
• Cycle the power and check the status indicator to see if the error is
still active.
• Contact your Graco distributor or Tech Service for more informa
-
tion.
12, 13 Alarm Internal Software Error
• Cycle the power and check the status indicator to see if the error is
still active.
• Contact your Graco distributor or Tech Service for more informa
-
tion.
Fast Flash Deviation
See Power Saving Mode , page 20.
Blink Code Error Type Troubleshooting Steps
Problem Cause Solution
Driver does not turn over and LED is
off Over voltage (greater than 300 V) • Check the power supply
No power to control board • Contact your Graco distributor or
Tech Service for more informa
-
tion.
Driver does not turn over and LED is
on Encoder fault • Cycle the power.
• Contact your Graco distributor or
Tech Service for more informa
-
tion.
Oil is leaking Oil was over-filled • Drain and refill as stated in
Check Oil Level ,
page 16.
Drain plug not tightened properly • Torque to 18-23 ft-lb (25-30
N•m).
Seal cartridge o-ring missing or dam
-
aged.
• Replace the shaft bearing
assembly.