Installation
Installation
Installation
Installation
Back
Back
Back---Gear
Gear
Gear Mounting
Mounting
Mounting Hole
Hole
Hole Dimensions
Dimensions
Dimensions
If using a new drum cover without holes, see below
for hole spacing dimensions.
Assembling
Assembling
Assembling and
and
and Positioning
Positioning
Positioning the
the
the
Agitator
Agitator
Agitator
All electrical wiring must be done by a qualified
electrician and comply with all local codes and
regulations. Only trained and qualified personnel
who have read and who understand the information
in this manual should install this equipment.
Always maintain a minimum of 1 in. (25.4 mm)
clearance between rotating agitator parts and
container to prevent sparks from contact.
Personal injury or equipment damage may result
from lifting/falling heavy equipment. To avoid
personal injury or equipment damage:
• Do not lift the drum cover and agitator without
proper assistance
• Do not walk or stand beneath a raised elevator.
With
With
With an
an
an Elevator
Elevator
Elevator
Mount the drum cover as described in manual
306287,
Elevators and Pump Supports
.
The elevator must be in the down position
when working on the elevator, agitator, or
drum cover assembly (for elevator operating
instructions, see manual 306287,
Elevators
and Pump Supports
). Proceed to step 1 in
With or Without an Elevator, page 8
.
Without
Without
Without an
an
an Elevator
Elevator
Elevator
If your system does not have an elevator, install the
Handles Kit to facilitate handling the drum cover and
agitator.
To order the Handles Kit, order Part No.
237524
.
Place two standard 55 U.S. gallon (45 Imperial gallon)
barrels 14 in. (approximately 36 cm) apart, and center
the drum cover on the barrels with the Graco logo
centered and facing you, as shown in Fig. 1. Proceed
to step 1 in
With or Without an Elevator, page 8
.
Figure 1 Drum Cover on Barrels
3A4548G
7
All manuals and user guides at all-guides.com
