Graco 24X960, Операция

Страница: 18 / 28

Repair
Reinstall Reinstall Reinstall Electronics Electronics Electronics Cover Cover Cover onto onto onto Driver Driver Driver (only (only (only
ifif if removed removed removed to to to replace replace replace the the the encoder encoder encoder cable) cable) cable)
Make sure wires are not pinched when re-installing
covers. Wires will be damaged and create an
electrical hazard and/or fire and explosion hazard
if pinched.
1. Plug in all connectors. Ensure all connectors
are securely attached to the control board (see
Wiring Schematic, page 26 ).
2. Secure loose motor wires into the clip inside the
housing (see
Wiring Schematic, page 26 ).
3. Reinstall electronics cover onto center housing.
4. Install the 12 bolts using a 6 mm hex wrench.
NOTE:
NOTE: NOTE: Ensure the lock washers are still in place.
5. Torque the bolts to 15 ft-lb (20 N • m).
Reinstall Reinstall Reinstall Motor Motor Motor Cover Cover Cover
1. Reinstall motor cover onto driver housing.
2. Install the four bolts and mounting lock washers
that hold on the motor cover using a 6 mm hex
wrench. Ensure the lock washers are still in
place.
3. Torque the bolts to 15 ft-lb (20 N • m).
4. Follow the Power Unit — Run Calibration
Procedure, page 15 .
Reattach Reattach Reattach Pump Pump Pump Lower Lower Lower
See the system manual.
18 3A8124A