Graco 24F561, Руководство по ремонту

Страница: 8 / 40

General Repair Information
8 3A1181B
General Repair Information
• Keep all screws, nuts, washers, gaskets, and electri-
cal fittings removed during repair procedures. These
parts usually are not provided with replacement kits.
• Test repairs after problems are corrected.
• If sprayer does not operate properly, review repair
procedure to verify you did it correctly. See
Trouble-
shooting, page 9 .
• Overspray may build up in the air passages.
Remove any overspray and residue from air pas-
sages and openings in the enclosures whenever
you service sprayer.
• Do not operate the sprayer without the motor shroud
in place. Replace if damaged. Motor shroud directs
cooling air around motor to prevent overheating and
insulates the control board from accidental electric
shock.
Flammable materials spilled on hot, bare, motor
could cause fire or explosion. To reduce risk of burns,
fire or explosion, do not operate sprayer with cover
removed.
To reduce risk of serious injury, including electric
shock:
• Do not touch moving or electric parts with fingers
or tools while testing repair.
• Unplug sprayer when power is not required for
testing.
• Install all covers, gaskets, screws and washers
before you operate sprayer.
NOTICE
• Do not run sprayer dry for more than 30
seconds. Doing so could damage pump
packings.
• Protect the internal drive parts of this sprayer
from water. Openings in the cover allow for air
cooling of the mechanical parts and
electronics inside. If water gets in these
openings, the sprayer could malfunction or be
permanently damaged.
• Prevent pump corrosion and damage from
freezing. Never leave water or water-base
paint in sprayer when its not in use in cold
weather. Freezing fluids can seriously damage
sprayer. Store sprayer with Pump Armor to
protect sprayer during storage.