Graco 24F561, Руководство по ремонту

Страница: 23 / 40

Pressure Control Assembly Replacement
3A1181B 23
Installation
1. Inspect pressure control before installation to verify
o-ring is installed.
2. Align pressure control wire cap (21) on fluid mani-
fold so opening faces toward motor.
3. Apply loctite to pressure control knob (B) threads.
4. Screw pressure control threads (B) into manifold
and torque to 150 in-lb (17.0 N.m).
NOTE: Be careful when tightening pressure control
knob that wires are not pinched between pressure con-
trol and fluid manifold.
5. Tuck wires into pressure control wire cap (21) and
route wires toward cap opening. Feed wires through
housing hole (K).
6. Insert bushing (23) in hole (K).
7. Connect pressure switch connector (A) to control
board (18).
8. Install shroud (12) and two screws (4) (see illustra-
tion, page 17) .
9. Hi-Boy Models Only - Connect high-pressure hose
at pump outlet (see page 14) .
K
o-ring
A
23
18
21
ti9129a
B