Graco 249161, Руководство по ремонту и запасным частям

Страница: 29 / 44

29
310944
Displacement Pump Replacement
Removal
1. Flush pump (79).
2. Relieve pressure ; page 6.
3. Fig. 16. Cycle pump with piston rod (A) in its
lowest position.
4. Fig. 16. Remove suction tube (97) and hose (65).
Fig. 16
A
65
97
79
5. Fig. 17. Use screwdriver: push retaining spring
(27) up and push out pin (112) from connection rod
cross link.
Fig. 17
112
27
6. Fig. 18. Loosen locknut with a hammer. Unscrew
pump.
Fig. 18
Repair
See manual 311061 for pump repair instructions.
Installation
If pin works loose, parts could break off due to force of
pumping action. Parts could project through the air and
result in serious injury or property damage. Make sure
pin and retaining spring are properly installed.
CAUTION
If the pump locknut loosens during operation, the
threads of the bearing housing will be damaged.
Make sure locknut is properly tightened.
1. Fig. 12. Pull piston rod out 1.5 in. Screw in pump
until holes in connecting rod cross link and piston
rod align.
Fig. 19
1.5 in.
2. Fig. 17. Push pin (112) into hole. And push retain-
ing spring (27) into groove all the way around
connecting rod.
3. Fig. 20. Screw locknut down onto pump until nut
stops. Screw pump into bearing housing until
locknut stops it. Back off pump and locknut to align
pump outlet to best position of hose to filter hous-
ing (69). Tighten locknut by hand, then tighten with
a hammer to approximately 75+ 5 ft-lb (102 N
S
m).
Fig. 20
4. Fig. 21. Fill packing nut with ASM TSL until fluid
flows onto the top of seal.
Fig. 21
ti3594a