308442 37
Service
Tighten the screws (24) to 18 in-lbs (2 N
m) maximum (about half
turn past snug), using the wrench (77) provided.
Install the nut (46) flush to the end of the piston rod (23g).
Adjust the nut (36) to create 0.125 in. (3 mm) gap between the
actuator arm (19) and the nut.
Make sure the entire fluid tube (33) is clear of the actuator
arm (19).
03901A
Fig. 32
26
24
20
27
27a
29
4
19
46
11
13
23g
36
43
33
Install the Gun onto the Manifold
1.
Make sure the gaskets (108, 121), and spring
(105) are in place on the manifold (101). See Fig.
33. Inspect the parts for damage and replace them
as needed.
2.
Secure the gun (B) to the manifold (101) by tight-
ening the three screws (106) with the ball end
wrench (77–not shown).
3.
Secure the gun (B) to the mounting bracket (102)
by tightening the screw (21) with the ball end
wrench (77).
Fig. 33
101
106
03218
102
21
B
121
108
105
