bly
Parts Needed: 4 each - PL55-5NM F, PL22-0NM G
(no assembly required)
, PL19-5NM E, PL48-5NM D
35 mm Cap Bolts
4 - Pole Caps (remove from cog wheels)
4 - Quick Release Springs
8 - Guide Dowels
4 - Quick Release Hooks
8 - Grabber Screws
“F”, “G”, and “E” Pole Assembly
<
First, you will assemble the “F” (55 ½") and “E” (19
½") poles. Gather these poles together along with the
grabber screws and Guide Dowels.
<
Insert a Guide Dowel into the ends of each “F”, and
“E” poles WITH THE SMALLER HOLE OF THE
GUIDE DOWEL INWARD.
<
Insert a grabber screw into a Guide Dowel. Using a
Phillips Screwdriver, screw the grabber completely into the rail.
“D” Pole Assembly
<
First attach the Quick Release Springs to the ends of the Quick Release Hooks. This is done by slipping
the springs over the knob as pictured.
<
Place the Quick Release Hook assembly into the slots
that are cut into the end of each “D” Pole.
<
Next place a plastic Pole Cap onto the end of each
“D”Pole. The slotted side of the Pole Cap goes in the
inside.
Connecting Pole to Pole
<
Look at the rails needed to make the size
you have selected. Align the slanted ends of the pole parts together and insert each bolt into the outside
hole. Continue inserting the bolt through to the metal T-nut insert.
<
Begin all the bolts by hand, then tightly holding the wood pole together align it squarely on all sides.
Line up this joint completely and then use the allen wrench to tighten all bolts.
Continue bolting
togther all slanted ends of poles until you have four Quilting Poles
.
Nylon Washer
(see next step
)
