12
Step 16: Crib Table and Frame End Assembly
Parts Needed:
2- Outer Leg Assemblies
2- Crib Track Supports
1- Right & Left Frame End Sub-Assembly
1- Right & Left Frame Corner
16- 6mm X 10mm SBHC Screws
8- 6mm X 12mm SBHC Screws
Tools Required:
4mm Allen Wrench
NOTE: The maximum width for a quilt made in
the Crib configuration is 50”. We recommend that
you build your Quilting Frame Queen size.
We recommend having someone hold up one end of the track support to help you with this step.
16-1: Secure each end of the Track Support to an Outer Leg
Assembly with four (4) 6mm X 10mm SBHC Screws using the
4mm Allen Wrench as indicated in Fig (16-1). Attach the Track
Support to the two Outer Leg Assemblies, with the Top Leg Brace
is to the inside. Repeat this step to assemble the other side of
the Frame.
16-2: Attach the Left Frame Corner to the Left Frame End as shown
in Fig (16-2); Use two (2) 6mm X 12mm SBHC Screws through the
Left Frame Corner and the Left Frame End into the Frame Assembly.
Tighten the 6mm X 12mm SBHC Screws with the 4mm Allen Wrench.
16-3:Use two (2) 6mm X 10mm SBHC Screws to attach the front of the Left
Frame End to the Frame Assembly. Tighten the 6mm X 10mm SBHC Screws
with the 4mm Allen Wrench. Repeat 16-2 and 16-3 to complete the Right Frame End.
Fig (16-1)
Step 17: Crib Table Supports & Table Surface Attachment
Parts Needed:
1- Crib Table Surface
3- Tables Supports
6- 5mm X 10mm
17-1: Attach all three (3) Table Support to the Track Support with
the 5mm X 10mm SBHC Screws. The Table Braces are
attached to the bottom side of the Track Support flange.
17-2: Start at one end of the Frame and remove the backing from
the Tape on the Track and Table Supports. Make sure the
TEXTURED side is facing UP. Line up the plastic Table Surface
with the Top Leg Braces and press the surface firmly in place.
Left Frame
Corner
6mmX12mm
SBHC
6mmX10mm
SBHC
Fig (16-2)