EN 24
Before Initial Use
• Remove all packaging materials and any possible protective
fi
lms used for protec-
tion during transportation.
Never remove the rating plate and any possible war-
nings!
• Before
you
fi
rst enjoy any fried food, we recommend that you carry out a trial run to
remove any possible production residues. To do this, allow the device to heat up on
the highest temperature setting for approx. 15 minutes without any food in it (see the
“Using the Device and Preparing Food” chapter). Make sure that the room is well
ventilated as you do this!
When the device is
fi
rst used, production-related additives (e.g. grease) may
cause a small amount of smoke and / or an odour to be produced. This is normal
and not a device defect.
• Clean the device and all accessories thoroughly (see the “Cleaning, Care and Sto-
rage” chapter).
Setting Up and Connecting the Device
PLEASE NOTE!
■
Place the device on a dry, level,
fi
rm and heat-resistant surface. Never place the
device on a soft surface. The ventilation slots on the bottom of the device must not
be covered. Otherwise it could overheat and be damaged.
■
Set up the device with a clear space on all sides (at least 20 cm) and clear space
above it (at least 30 cm).
■
The device has rubber feet. Some items of furniture are coated with materials which
could attack the rubber feet. If necessary, place a mat under the device to be on the
safe side.
1. Set up the device in a suitable location, following the safety instructions and the
notes provided at the beginning of this chapter.
2. Fully unwind the mains cable.
3. Insert the mains plug into a properly installed socket that is easily accessible. A beep
will be heard and all the elements in the display will light up once. All elements then
go out again.
Safety Features
• The device is equipped with an internal timer. Once the set timer time has elapsed,
the supply of heat is automatically switched off. To switch the device on again, touch
the
fi
eld
(
20
)
(see the “Using the Device and Preparing Food” chapter).
• The device switches off automatically when the drawer (
5
) with the basket insert
(
8
) is removed from the device. All elements on the display (
10
) go out. When the
drawer is inserted back into the device, a beep sounds, all elements light up once on
the display and then go out again. The display shows the symbol for the previously
selected programme (
“Manual”
programme excluded) and the set temperature and
the remaining timer time appear on the LED display (
21
). The set programme con-
