MONKEY BAR RUNNER LEFT
MONKEY BAR RUNNER RIGHT
TOP SIDE
ANGLED END
5/16" TEE NUT
TOP
#10 x 2"L SELF TAPPING SCREW
1-5/16" DIAMETER X
19.75" L RUNG
ANGLED END
MONKEY BAR RUNNER - LEFT
MONKEY BAR RUNNER - RIGHT
TOP SIDE
ANGLED END
TOP SIDE
5/8"
24" TO 24-1/4"
WHEN ASSEMBLED
LARGE
HOLE
Note: Inside each
RUNG there is a
WELD SEAM.
Make sure this SEAM
points toward
the END of the runner
before installing
the self-tapping screws.
Predrill 1/8" hole
thru wood thru top
surface of rung.
Then install a self-
tapping screw.
WELD SEAM
WELD SEAM
1: PLEASE NOTE: THERE IS A LEFT AND RIGHT MONKEY BAR RUNNER. (See bottom left pictures below.)
2: START WITH THE 4 X 4 X 70" MONKEY BAR RUNNERS. WITH THE FIVE LARGE HOLES FACING YOU
INSTALL A 5/16" TEE NUT INTO THE TWO SMALL HOLES AT THE ANGLED END OF EACH MONKEY BAR
RUNNER.
3: SEE
TOP
BELOW. LOCATE FIVE 1-5/16" DIAMETER X 19.75" LONG CYLINDRICAL MONKEY BAR RUNGS.
LAY THE
LEFT
MONKEY BAR RUNNER ON THE GROUND WITH THE LARGE HOLES FACING UP. INSERT A
RUNG INTO EACH LARGE HOLE WITH THE WELD SEAM INSIDE THE RUNG FACING THE
END
OF THE
RUNNER. YOU MAY HAVE TO USE A RUBBER MALLET TO SEAT THE RUNG AGAINST THE BOTTOM OF EACH
LARGE HOLE.
DO NOT
ATTACH THE
RIGHT
MONKEY BAR RUNNER TO THE RUNGS YET.
4: SEE
BOTTOM
AT RIGHT BELOW. THE BOTTOM SIDE OF EACH MONKEY BAR RUNNER HAS ONLY ONE
LARGE HOLE IN IT. MEASURE 5/8" FROM THE INSIDE EDGE OF THE MONKEY BAR RUNNER AND MAKE A
MARK CENTERED OVER THE RUNG. MAKE SURE THE RUNG IS SEATED AGAINST THE BOTTOM OF HOLE.
PREDRILL A 1/8" PILOT HOLE THROUGH THE WOOD, THEN THROUGH THE TOP SURFACE OF THE RUNG
FACING YOU. NEXT, DRIVE A #10 X 2"L SELF TAPPING SCREW THROUGH THE WOOD INTO THE RUNG.
REPEAT THIS STEP FOR EACH RUNG, PREDRILLING THEM ONE AT A TIME AND THEN INSTALLING A #10 X
2"L SELF TAPPING SCREW.
5: PLACE THE
LEFT
MONKEY BAR RUNNER WITH THE RUNGS ATTACHED TO IT ON THE GROUND WITH THE
RUNGS POINTING UPWARDS. LOCATE THE
RIGHT
MONKEY BAR RUNNER AND PLACE THE FIVE LARGE
HOLES ONTO THE RUNG ENDS. IF NECESSARY USE A RUBBER MALLET TO SEAT THE RUNGS INTO THE
BOTTOM OF EACH LARGE HOLE. PLACE THE MONKEY BAR RUNNER ASSEMBLY DOWN FLAT ON THE
GROUND WITH THE SCREWS FACING YOU. REPEAT STEP 4.
STEP 2: ASSEMBLING THE MONKEY BAR ASSEMBLY
BOTTOM
END
19
