MONKEY BAR UNIT
WAVE SLIDE
IF PLAYSET IS ASSEMBLED REMOVE THE
THREE 5/4 X 4 X 28-1/2" PANEL SLATS
IN THIS AREA
B
DETAIL B
SCALE 1 : 20
FLUSH
3/8" X 5" HEX LAG SCREW
3/8" FLAT WASHER
MONKEY BAR RUNNERS
CORNER POST
CENTER POST
SIDE RAIL
FLUSH
NOTE:
PANEL
SLATS
REMOVED
STEP 4: ATTACHING THE MONKEY BAR UNIT
TO THE PLAYSET
1: IF YOUR PLAYSET IS ALREADY ASSEMBLED AND YOU PURCHASED THE MONKEY BAR ADD ON
KIT THEN YOU MUST REMOVE THE THREE 5/4 X 4 X 28-1/2" PANEL SLATS IN THE AREA SHOWN IN
THE TOP RIGHT PICTURE BELOW. SAVE THE PANEL SLATS FOR INSTALLATION IN STEP 6.
2: POSITION THE MONKEY BAR UNIT AS SHOWN BELOW NEXT TO THE WAVE SLIDE. A SECOND
PERSON WILL BE NEEDED FOR THIS STEP.
3: MAKE THE END SURFACE OF THE MONKEY BAR RUNNERS FLUSH WITH THE CORNER POST AND
CENTER POST. MAKE THE TOP SURFACE OF THE MONKEY BAR RUNNERS FLUSH WITH THE
BOTTOM SURFACE OF THE SIDE RAIL. HAVE AN ASSISTANT HOLD EACH MONKEY BAR RUNNER IN
POSITION WHILE YOU DRIVE IN TWO 3/8" X 5" HEX LAG SCREWS WITH TWO 3/8" WASHERS
THROUGH THE HOLES IN THE MONKEY BAR RUNNER END.
21
