This page is a list of definitions and explanations used throughout our instructions to aid you
in the assembly of your play set.
Lag Screws-
Lag screws are used in the construction of our playsets to enhance the structural
integrity of the unit. There will not be predrilled holes in the post for lag screw installation. Lag
screws are self-tapping, though if you are using a manual socket wrench it may be necessary to
tap the head of the lag screw with a hammer. You should also be sure to tighten the lags
completely. Power tools such as an impact wrench or power drill should have enough torque to
drive the lag screws without using a hammer, but make sure not to over tighten as this can cause
the threads to “strip out” in the post.
EXAMPLE OF OFFSET HOLES UP
Offset Holes
-
Throughout the installation procedures we will refer to parts with offset holes.
This refers to the orientation of the holes on the board. An offset hole is one that is closer to one
side than it is the other or in other words, it is not centered on the board. In the procedures you
will be instructed to attach the boards with the holes offset up or with the holes offset down. This
refers to which side of the board the hole/holes should be closer to. Offset holes up= hole/holes
will be closer to the top of the board. Offset holes down= hole/holes will be closer to the bottom
of the board. Note: some parts do not have offset holes, but instead the holes are on center.
Therefore there will not be any reference to how to offset these parts.
Counter-sunk holes-
Many of the parts that will be used have counter-sunk holes. A
counter-sunk hole is one that surrounds one side of a thru hole, but does not extend through the
wood itself. When using a counter-sunk hole the bolt will be inserted through the thru hole and
either the head of the bolt and washer or nut and washer will occupy the counter sunk hole.
13
