Gorgon G303, Руководство по эксплуатации

Страница: 12 / 16

Gorgon G3O3
DESCRIPTION OF THE PROGAMMABLE SETTINGS OF THE SYSTEM
LEVEL 1 – storing the remote units to the system’s memory.
The system is capable to keep in memory the codes of three remote control units – one at each of
the sublevels. Every time it is necessary to record the codes of all the remote units that will be used later
on. If one remote unit is in use then its code must be recorded three times (at each of the sublevels). When
two units are in use the code of one of them must be recorded twice.
If a remote unit is lost the codes of the remaining units must be recorded anew in order to erase from
their memory the code of the lost one.
Sublevel 1.1 - recording the first remote unit
LED shines with red light. Press and release any button of the remote control, the LED keeps on shin-
ing with red. Press any button of the remote unit once again. Frequent red and green flashes correspond
to a successful storing of the first unit to the system’s memory. After that the system automatically goes on
to the next sublevel of the first level.
Sublevel 1.2 - recording the second remote unit
The second unit is stored to the memory of the system the same way as the first one.
Sublevel 1.3 – recording the third remote unit
The third unit is stored to the memory of the system the same way as the first one. Upon completion
of recording the LED goes down and the system is waiting for a new level entry.
LEVEL 2 – entering a secret code.
Secret code, composed of two digits from 1 to 16, provides control over the system when the remote
unit is not available (see “System Control over a Secret Code” clause).
Factory setting of a secret code is «1 – 1».
CAUTION! Remember and write your secret code down and keep it some
place outside the vehicle. You won’t be able to control the system and to
change its settings without the remote control unit. Change the preset secret
code for the safety sake before you start using the system.
Sublevel 2.1
The LED is not alight. Enter the first digit of a secret code by entering the “VALET” button conse-
quently with the required number of times with the interval not more than 1 second. The system will repeat
the entered number by the LED’s green flashes. Enter the second digit in the same manner as the first one
and the system will also reproduce it.
Upon completion of both digits entering the LED will be shining with a dim green light – this means
that the system is waiting for repeated code entering for the purpose of its comparison and confirmation.
Repeat the code entering by the “VALET” button with an interval between the first and the second digits
of approx. 2 seconds. If the code does not coincide with the one that has been inserted before, the LED
will produce a red signal on the background of a dim green light. For a new attempt press and hold the
“VALET” button until the LED stops flashing. If the second entering is correct the system will report accept-
ance with frequent red and green flashes.
After that, the LED goes down and the system is waiting for a new level number entering.
My personal secret code is: -
LEVELS 3 -7
LED status: green- work is allowed, red- work is prohibited.
Settings change: remote’s button “1” – to allow, button “2” – to prohibit.
“VALET” button pressing: to store the current setting and go to the next sublevel.
Sublevels 5.4, 6.7- timer duration setting
The LED shines with red light. Press and hold the “VALET” (the LED will shine with green light) for
a period equal to the required by the timer duration. During the “VALET” button releasing the timer work
duration is captured, the system confirms a successful recording by frequent red and green lights of the
LED, whereupon the LED goes down and the system is waiting for a new level number entry.
Timer work duration range: 1 second to 40 minutes.
Turn the ignition on if you don’t want to change the sublevel settings.