Gorenje WA71141, Инструкция по эксплуатации

Страница: 20 / 32

300526
20
Failure Possible cause Remedy
FAILURE 7
Water is poorly pumped
out or not at all (machine
reports failure - the LEDs
periodically
fl ash seven
times).
Water outlet is clogged Check if:
• the
fi lter is clean,
• outlet pipe is not jammed,
• the drain is clogged,
• outlet pipe is positioned higher than
1m.
Push START again
Laundry is not properly
spun.
No failure is reported. The machine switched on the
UKS function. Because of bad
laundry balance, the machine
has automatically reduced spin
RPM. The machine operates normally.
Wash large and small pieces of
laundry together.
Greasy wads appear on
the laundry. Too little detergent (laundry was
very greasy). Wash the laundry again.
Add more detergent for such soiled
laundry, or use liquid detergent.
Laundry is stained after
washing. You used liquid detergent or
detergent for colored laundry
which does not contain
whitener. Use the detergent containing
whitener.
White powdery residues
on the laundry. It is not the consequence of
bad rinsing, but because of
neo-phosphate detergents
containing non soluble
components (zeolites) for water
softening. Such substances may
be deposited upon the laundry. Immediately rinse the laundry once
again.
• Use liquid detergents which do not
contain zeolites.
• Try removing the residues with the
brush.
Detergent residues in the
dispenser. Low water fl ow pressure.
Some detergents may stick to
the dispenser rather hard if it
is wet.
• Clean the inlet pipe fi lter net.
• In case of low water pressure
increase water level.
• Wipe the dispenser prior loading
detergent.
Softener is not completely
rinsed, or water is left in
the dispenser dish. Sucking cover is not correctly
positioned or is clogged. Clean the dispenser and fi rmly fi x the
cover to its place.
Unpleasant smell in the
washing machine drum. • Remains of fabrics, washing
agent and softener in the fi lter.
• Development of germs
• Check whether the fi lter is clean.
• Run the auto-clean (SterilTub)
program (see chapter: selecting
additional functions)
Washing time is longer
than usual. • Low temperature of inlet water.
• Due to unevenly distributed
load, the machine has
activated the UKS*.
• Low mains voltage.
• There has been a failure in the
power supply.
• Washing program time may be up
to 60% longer; however, this does
not imply a fault in the machine.
• Washing time is extended by the
power supply down-time.