Gorenje SGT 2400 B, Инструкция по эксплуатации

Страница: 48 / 119

48
DRY IRONING
1. Unwind and straighten the power cord and supply cord.
2. Connect the appliance to a suitable mains supply outlet.
3.
“Beep” sound would be heard and the LCD would display all logos for a Second then turn off.
4. Press the power On/Off button
5. The medium steam level (
) and ( ) Medium hard water level indicator will display in the
LCD with a beep sound.
6. The will blink to indicate; the base unit is heating up or cooling down.
7. Turn the Temperature Dial on the iron in clockwise direction
; select „

‟ (1 dot), „

‟ (2 dots) or „

‟ (3
dots) according to the recommendation of garment label.
8. Pilot Light glow until the required temperature for the iron unit is reached.
9. Select the dry iron indicator (
) by press the “-“LCD control button, a beep sound would be heard
for each LCD control button pressing.
10. If the steam generator has the steam pressure, the pressure indicator will display in the LCD
.
11. Pilot Light goes off when the required temperature for the iron unit is reached.
12. The appliance is ready to use.
13. Turn the Temperature Dial on the iron unit in anti-
clockwise direction to “Min” and the iron is
switched off.
14.
Press the Power On/Off switch, the base console will switch to “Standby mode” with a beep sound.
15. Disconnect the power cord from mains supply outlet.
16. When the appliance gets cool completely, store it in a safe place. For the power cord & steam supply
cord storage see the Fig 2
AUTO SHUT-OFF
Auto shut off system will activate if appliance is not used over 10 minutes. LCD display
back light goes off with a beep sound and the pause icon will blink. When this occurs,
press the Power ON/OFF button once, the appliance will switch ON immediately. Wait
about one and half minutes for the appliance to heat up to the temperature set before
WATER HARDNESS SETTING
1. Unwind and straighten the power cord and supply cord.
2. Connect the appliance to a suitable mains supply outlet.
3.
“Beep” sound would be heard and the LCD would display all logos for a Second then turn off.
4. Press the power On/Off button
5. The medium steam level (
) and ( ) hard water level indicators will display in the LCD with
a beep sound.
6. The icon will blink to indicate; the steam generator is heating up or cooling down for the steam
ironing.
7. Press once the water hardness setting button, them icon will display in the LCD with a beep
sound
8.
Select your usage water hardness by press the “-, +” LCD control buttons; Soft water (
) or Hard
water ( ) or Very Hard water ( ), a beep sound would be heard for each pressing.