Gorenje GU64160, Руководство по эксплуатации

Страница: 15 / 24

Action Possible causes Problem
Check that the salt compartment lid is
properly tightened. Otherwise call the
service department. The water softener is leaking salt. Spots or films on the dishes.
See the section Settings. Incorrect water softener setting.
See the sections Before washing for the
first time and Settings. Incorrect rinse aid dosage setting.
Top up with salt. See the section Before
washing for the first time. Salt compartment empty.
Inactivate the setting TAB (3-in-1/
All-in-one detergent) and top up salt and
rinse aid. 3-in-1/ All-in-one detergent is used and
the setting TAB (3-in-1/ All-in-one
detergent) is activated.
Wash crystal at a low temperature and
with a conservative amount of detergent.
Contact the detergent manufacturer. Too high temperature and/or too much
detergent can cause etching on crystal.
Unfortunately, this cannot be repaired,
only prevented.
Reduce the amount. See the sections
Before washing for the first time and
Settings. If you have very soft water, you
may want to dilute the rinse aid 50:50
with water. Rinse aid dosage setting too high. The dishes have a sticky white/blue film.
Use a detergent with a bleaching agent. Lipstick and tea can be difficult to wash
off. Spots left after washing.
Check that the dishes are placed
securely. Spin the spray arms to make
sure they can rotate. The dishes are not correctly placed or
the spray arms are not rotating. Rattling sound when dishwashing.
None, next time the programme is run
the corrected time will be displayed. The programme is taking longer than
estimated. 1 minute appears in the display.
Loosen the drainage hose where it
connects to the sink unit's water trap.
Check that no debris has fastened. Is
the cone-shaped part of the pipe cut to
an inner diameter of at least 14 mm? Blocked drainage hose. Water remains in the dishwasher.
Check that the hose is free from kinks
and sharp bends. Kink in drainage hose.
Clean the coarse and fine filters. The filters are blocked.
Clean the drainage pump. See the
section Care and cleaning. Debris in the drainage pump.
Clean with washing-up brush and low
foaming cleaner. Dirt around the seals and in corners. Bad odour in dishwasher.
Run a programme with a higher
temperature about once a month. Low temperature programmes have
been selected for a prolonged period.
15