Gorenje GU64160, Руководство по эксплуатации

Страница: 18 / 24

Placing the dishwasher
The dishwasher is intended for installation under a worktop.
The recess dimensions are illustrated. Holes for wires/cables
need not be larger than 38 mm in diameter. Make sure the
edges of such holes are even to prevent damage to the
drainage and inlet hoses and the power cable.
570
55
125
820-870
Adjust the height and slide the dishwasher
into place
1
Start by measuring the height from the floor to the
bottom edge of the worktop.
2
Measure the height from the floor to the top edge of the
dishwasher.
3
Adjust the dishwasher's feet by turning them clockwise
to raise or anticlockwise to lower the machine.
24 mm
4
Check that there is an air gap of at least 3 mm between
the underside of the worktop and the top edge of the
dishwasher.
5
Slide the dishwasher into place.
•
Pull through the drainage and supply hoses when
the machine is slid into place.
•
Check that the hoses have no kinks or sharp bends,
and check that there is nothing that can damage the
hoses.
6
Make any final adjustments to the front feet (the
dishwasher may lean no more than 5 mm).
Drainage connection
min.
14 mm
min. 350 mm 350-950 mm
The drainage hose may be extended by a maximum of 3 m
(the total length of the drainage hose must not exceed 4.5
m). Any joins and connecting pipes must have an internal
diameter of at least 14 mm. However, the drainage hose
should ideally be replaced with a new hose without joins.
No part of the drainage hose may be more than 950 mm
above the bottom of the dishwasher. The hose must not be
routed directly to a floor drain or the like. In such cases, the
hose can act as a siphon and empty the dishwasher.
The hose must always discharge at least 350 mm above
the bottom of the machine.
Ensure that the drainage hose has no kinks.
18